In this article, we will be teaching you how to charge, assemble and use your Social vape pen.
When you first open the re-sealable bag, it will look like the image below.
The vape top will already be screwed onto the battery. We recommend you charge your battery before use.
How To Charge Your Pen
Affix the USB charger on top of the battery by screwing it in
then plugging into any USB charger or computer.
A flashing battery will indicate one of two things- dead battery or a short in the coil (cartridge). The end tip lights up while it’s charging and then goes out when it’s finished. Charging should only take about 2-4 hours to achieve a full charge.
Your battery will likely come pre-charged, in which case it won't light up when plugged in.
How To Use Your Pen
Remove the small rubber stopper from the tip of the oil cartridge. Do not throw the rubber stopper away as you may need this later for storage.
Affix the cartridge on top of the battery by screwing it in clockwise. Be careful to not over tighten the cartridge as this can damage it.
Now you are ready to vape! All you have to do is simply inhale from the mouthpiece. The bottom will light up as you are inhaling. You can take up to an 8 second inhale. Make sure you are inhaling all the way and release.
If your pen starts to feel hot you should let it cool down for a few minutes in order to avoid burning the oil.
Storage: If you are not using your pen for a few days place the rubber stopper back on the mouthpiece and store the cartridge upright in a cool, dark place.